User manual

Modem/Router, and if your ADSL service provider uses PPPoE.
•
PPTP - The Point to Point Tunneling Protocol is more common in corporate
environments and most users will not use this setting.
•
L2TP - The Layer 2 Tunneling Protocol is more common in corporate
environments and most users will not use this setting.
The relevant section immediately below depends on the WAN Type you selected.
Configuring the Built-in 3G+ Modem
The page shown below only appears if you select the Built-in Mobile Broadband
modem button on the Select WAN Type menu. Otherwise skip this section.
On the Setup 3G+ page, Auto-Detection is enabled by default to automatically detect your
SIM card provider. A message will show whether auto-detection was successful or not. If
auto-detection was successful, click Next. If auto-detection failed to detect your SIM card
provider, click OK to close the message box and then select Manual Setup. On the Manual
Setup page select your Country, and then select the name of your Service Provider from
the drop down list. The rest of the fields on the page are automatically filled in. If a field is
left empty, don’t worry since that field is not used for your provider. Click Next.
Note: If your country or service provider does not appear in the dropdown list you
must manually enter your service providers settings. This can be done by selecting
Manual Setup and entering your settings manually or by using the Basic Setup page.
Please see
Chapter 7, Using the Configuration Manager’s Advanced Program for
how to configure the Basic Setup page.
Go to
Step 4. Wireless Settings.
Chapter 3: Using the Modem/Router’s Configuration Manager 15