Tus neeg siv phau ntawv

owner’s manual
4
Three-minute protection feature
A protection feature prevents the air conditioner from being
activated for approximately 3 minutes when it restarts immedi-
ately after operation.
Power failure
Power failure during operation will stop the unit completely.
The OPERATION lamp on the indoor unit will start
flashing when power is restored.
To restart operation, push the ON/OFF button on the
remote controller.
Lighting or a car wireless telephone operating nearby
may cause the unit to malfunction.
Disconnect the unit with the power and then connect the unit
with the power again. Push the ON/OFF button on the remote
controller to restart operation.
4. HINTS FOR ECONOMICAL OPERATION
Adjust the air flow direction properly to avoid winding toward
your body.
Adjust the room temperature properly to get a comfortable
situation and to avoid supercooling and superheat.
In cooling, close the curtains to avoid direct sunlight.
To keep cool or warm air in the room, never open doors or
windows more often than necessary.
Set the timer for the desired operating time.
Never put obstructions near the air outlet or the air inlet. Or it
will cause lower efficiency, even a sudden stop.
The following should be noticed to ensure an economical operation.
(Refer to corresponding chapterfor details)
If you don't plan to use the unit for a long time, please discon-
nect power and remove the batteries from the remote control-
ler. When the power switch is connected, some energy will be
consumed, even if the air conditioner isn't in operation. So
please disconnect the power to save energy. And please
switch the power on 12 hours before you restart the unit to
ensure a smooth operation.
A clogged air filter will reduce cooling or heating efficiency,
please clean it once two weeks.
With this new technology, the dipsplay area will appear EC (if
applicable) and the LED indication lamps continue flashing
when the outdoor unit detects refrigerant leakage.
Louver Angle Memory Function(optional):
For some models, the machine is special designed with louver
angle memory function.Power failure during operation or
pressing the ON/OFF button on the remote controller will stop
the unit completely.When the power restores or pressing the
ON/OFF button on the remote controller again,the unit restarts
automatically with the previous open angle of the horizontal
louver by the memory function.So we strongly recommend that
the open angle of the horizontal louver should not be set too
small,in case the condensed water forms and drops from the
horizontal louver. Press the Manual control button and the open
angle of the horizontal louver will be restored to the standard
angle.
Refrigerant Leakage Detection(optional):
5. ADJUSTING AIR FLOW DIRECTION
Auto-swing
Auto-swing
Press SWING V button, the louver will swing up and down
automatically.
Manual Swing
Adjust the louver to achieve better cooling/heating effects
when cooling /heating.
Press SWING H button, the louver will swing left and right
automatically.
When cooling
Adjust the louver horizontally.
When heating
Adjust the louver downwards. (vertically)
Fig. 5-1
Fig. 5-2
Fig. 5-3
6. MAINTENANCE
Before you clean the air conditioner, be sure the power
supply is off.
Check if the wiring is not broken off or disconnected.
Use a dry cloth to wipe the indoor unit and remote
controller.
CAUTION
Fig. 5-4
,
,
5.2 Adjust the Vertical louver
5.1 Adjust the horizontal louver