Installation manual

PROGRAMMING MODE 21

[001] - [008] Group Zone Assignments

[001] Group A Zone Assignment

[002] For Future Use

[003] Group B Zone Assignment

[004] For Future Use

[005] Group C Zone Assignment

[006] For Future Use

[007] Group D Zone Assignment

[008] For Future Use

When an Address is entered, the 8 zone lights on the keypad will be used to indicate which zones have been

assigned to which Groups.

• When a zone light is OFF, that zone has not been assigned to the group

• When a zone light is ON, that zone has been assigned to the group

For example, enter Address [001]. With the factory default program in place, zone lights 1 through 8 will be ON,

indicating that zones 1 through 8 have been assigned to Group A.

To select a zone, press the number key corresponding to the desired zone light. For example, in Address [001],

press 1 to select zone 1, 2 to select zone 2, and so on. When in other Addresses, refer to the Programming

Worksheets to determine which zone lights represent which zones.

Pressing a number key to select a zone will either turn the desired zone light ON or OFF:

• If the zone light is ON, pressing the key will shut the light OFF

• If the zone light is OFF, pressing the number key will turn the light ON

Note: When using end-of-line resistor zones, trouble zones will be assigned to the same group as their respective

alarm zones.

[009] - [010] Group A Access Code Assignment

When an Address is entered, zone lights 1 to 8 on the keypad will be used to indicate which Access Codes have

been assigned to the group.

• When a zone light is OFF, that Access Code has not been assigned to the group

• When a zone light is ON, that Access Code has been assigned to the group

For example, enter Address [009]. With the factory default program in place, zone lights 1 through 8 will be ON,

indicating that Access Codes 1 to 8 have been assigned to Group A.

To select an Access Code, press the number key corresponding to the desired zone light. For example, in

Address [009], press 1 to select Access Code 1, 2 to select Access Code 2, and so on.

Pressing a number key to select an Access Code will either turn the desired zone light ON or OFF:

• If the zone light is ON, pressing the key will shut the light OFF

• If the zone light is OFF, pressing the number key will turn the light ON

[011] - [016] For Future Use

[017] Group A Special Access Code Assignment

User Numbers 65 through 70 are used to assign the Auto-Arming, Quick-Arming, Keyswitch Arming and

Central Station Arming functions to Group A. For these functions to be operational for Group A, they must be

selected in this section.

Refer to the Programming Worksheets for information on which Code is used for which feature. To enable

these features for a Group, turn the desired Zone Light ON by pressing the corresponding number key. If a

feature is assigned to the Group, its Zone Light will be ON; if a feature is not assigned, its Zone Light will be

OFF.

When these events occur, they will be reported to the central station by User Numbers 65 through 70.

[018] - [024] For Future Use