Installation manual

Remote Control of Programmable Outputs, Bell Output and Keypad Sounder

Note: All the Programmable Outputs, the Bell and the Keypad Sounder can be controlled by the central station.

Each can be activated by the following commands:

Command Action

Ax Turn ON

Bx Turn OFF

Cx Pulse Once for 1 Second

Dx Flash (continued pulsing; does not apply to the Bell output)

A command from the central station always has priority over the normal programmed function. The only exception

applies when Programmable Output 1 is programmed for use with a printer.

For remote controlled operation, the central station accesses the outputs as control pointed according to the

following:

Control Point (x) Output

1 Programmable Output 1

2 Programmable Output 2

3 Keypad Sounder

4 Bell

5 Programmable Output 3

Programmable Output Types