Specifications

KVM Switch User’s Guide
7
Initial Power-Up Process
Make sure all computers and KVM Switches are powered down
during installation. You must power up the Master KVM Switch
before turning on any other devices.
 For single KVM Switch:
1) Apply a power adapter to the Master. (after cables connected)
2) Turn on computers.
 For cascade:
1) Apply a power adapter to the Master.
2) Apply power adapters to all Slaves.
3) Turn on computers.
Note: You may hot plug any powered-down computer and Slave KVM at any
time after initial power up process completed.
Hot Plug Capability
Master Console Devices Replacement
You can replace a keyboard or mouse of the Master
CONSOLE port at any
time without powering down the Master KVM.
PC Port Hot Plug and Hot Swap
You can plug in or out of PC port or swap PC port at any time without
powering down the KVM.
Note: Some PC was not support PnP configuration and it will need to
rebooting after Hot swap.
In case, some devices need to rebooting or software driver initial, you
may press the Reset button in the KVM front panel to re-start the
KVM initial process.