6 port 10/100 Switch Quick Installation Guide
16 port 10/100 Ethernet Switch Introduction The 16 port Ethernet Switch are designed to allow simultaneous transmission of multiple packets via an internal high-speed data channel. This means that it can partition a network more efficiently than bridges or routers in most environments. This 16 port Ethernet Switch is a highly reliable network Switch and is the ideal device for bridging Ethernet to Fast Ethernet workgroups or networks.
16 / port 10/100 Ethernet Switch Spectification Standard: IEEE802.3 10Base-T Ethernet IEEE802.3u 100Base-TX Fast Ethernet Network Media: 100Base-TX - UTP/STP category 5 cable 10Base-T - UTP/STP category 3 or 5 cable Connector: STP RJ-45 port for 10/100Mbps TX LED indicators: System – Power LED.
16 port 10/100 Ethernet Switch ： Features Complies with IEEE 802.3/802.3u Ethernet standard Provided with 16/24 10/100Mbps RJ-45 ports - Flow control is provided - Full and Half duplex mode operation - Built-in Storage of more than 1K MAC address - Automation source address learning - IEEE802.
16 port 10/100 Ethernet Switch Hardware Overview Before you start to setup your network with your Switching Hub, browse through this section first and familiarize yourself with the various components of the hub. This section shows what the front and rear panels look like and briefly explains what each component is intended for.
16 port 10/100 Ethernet Switch LED Definition: Please refer to the following table for LED definition Front Panel 16 Ports 10/100 Internal Power Switch LED Power Status Green Link/act Green Operation Lit: Power is on Lit: Indicates the adapter is connected to swich correctly Flash: the port is transmitting/receiving data.
16 port 10/100 Ethernet Switch Hardware Installation Place the 16 port Switch on a smooth surface Connect the output of power cord to the AC-inlet of 16 port Switch. Connect other IEEE802.3 compatible network device(Hub ,Switch ,PC) to one port of the 16 port Switch using Category 3/4/5 UTP/STP cabling. Connect another IEEE802.3 compatible network device (Hub , Switch ,PC) to another port of 16 port Switch by following the same process as described in Step3.
16 port 10/100 Ethernet Switch Connecting Computers to the Switching Hub After placing the Switching Hub to your desired location, you can now start to setup your network. The first thing you can do is to start connecting computers. You can connect servers and workstations to the Switching hub. As you follow through the installation procedure in this section, please take a close look on the connectivity rules indicated. Make sure you follow them to setup your network properly. 1.
16 port 10/100 Ethernet Switch Interconnecting Hubs Follow the setup diagram and procedure below to connect a second Switching Hub or any compatible Switch.
16 port 10/100 Ethernet Switch Troubleshooting If the 16 port Switch is not functioning properly, make sure the 16 port Switch was set up according to instructions in this manual. The Power LED is not lit Solution: a. Check if the AC power cord is well connected. Try to unplug and plug back the power cord to the LAN Switch or try another power cord. b. Check if the AC power source is in good condition. The Link LED is not lit Solution: a.
