User guide

Router Installation
36 Check Point ZoneAlarm User Guide
5. Thread the anti-theft device's pin through the bolt’s holes, and insert the pin
into the main body of the anti-theft device, as described in the documentation
that came with your device.
Router Installation
Installing the ZoneAlarm Router
To install the ZoneAlarm router
1. Verify that you have the correct cable type.
For information, see Network Requirements on page
7.
2. Connect the LAN cable:
• Connect one end of the Ethernet cable to one of the LAN ports at the back of
the unit.
• Connect the other end to PCs, hubs, or other network devices.
3. Connect the WAN cable:
• Connect one end of the Ethernet cable to the WAN port at the back of the unit.
• Connect the other end of the cable to a cable modem, DSL modem, or office
network.
4. Connect the power supply to the power socket, labeled PWR, at the back of the
ZoneAlarm router.
5. Plug the power supply into the wall electrical outlet.
Warning: The ZoneAlarm router power supply is compatible with either 100, 120 or
230 VAC input power. Verify that the wall outlet voltage is compatible with the
voltage specified on your power supply. Failure to observe this warning may result
in injuries or damage to equipment.