User guide

Securing the ZoneAlarm Router against Theft
Chapter 3: Installing and Setting Up ZoneAlarm 35
While these parts may differ between devices, all looped security cables include a bolt with
knobs, as shown in the diagram below:
The bolt has two states, Open and Closed, and is used to connect the looped security cable
to the router's security slot.
To install an anti-theft device on the ZoneAlarm router
1. If your anti-theft device has a combination lock, set the desired code, as
described in the documentation that came with your device.
2. Connect the anti-theft device's loop to any sturdy mounting point, as described
in the documentation that came with your device.
3. Slide the anti-theft device's bolt to the Open position.
4. Insert the bolt into the ZoneAlarm router's security slot, then slide the bolt to
the Closed position until the bolts holes are aligned.
Figure 5: Looped Security Cable Bolt