User guide

Wall Mounting the ZoneAlarm Router
Chapter 3: Installing and Setting Up ZoneAlarm 33
3. Mark two drill holes on the wall, in accordance with the following sketch:
4. Drill two 3.5 mm diameter holes, approximately 25 mm deep.
5. Insert two plastic conical anchors into the holes.
Note: The conical anchors you received with your ZoneAlarm router are suitable for
concrete walls. If you want to mount the router on a plaster wall, you must use
anchors that are suitable for plaster walls.
6. Insert the two screws you received with your ZoneAlarm router into the plastic
conical anchors, and turn them until they protrude approximately 5 mm from
the wall.
7. Align the holes on the ZoneAlarm router's underside with the screws on the
wall, then push the router in and down.
Your ZoneAlarm router is wall mounted. You can now connect it to your computer.