User guide

Resetting the ZoneAlarm Router to Defaults
Chapter 17: Maintenance 363
To reset the ZoneAlarm router to factory defaults using the Reset button
1. Make sure the ZoneAlarm router is powered on.
2. Using a pointed object, press the RESET button on the back of the ZoneAlarm
router steadily for seven seconds and then release it.
3. Allow the ZoneAlarm router to boot-up until the system is ready.
For information on the router's front and rear panels, see the Getting to Know Your
Router section in Introduction on page
1.
Warning: If you choose to reset the ZoneAlarm router by disconnecting the power cable
and then reconnecting it, be sure to leave the ZoneAlarm router disconnected for at
least three seconds. Disconnecting and reconnecting the power without waiting might
cause permanent damage.