User guide

Email Filtering
284 Check Point ZoneAlarm User Guide
Note: If the ZoneAlarm router is remotely managed, contact your Service Center
administrator to change these settings.
To enable virus and spam scanning for a protocol
1. Click Services in the main menu, and click the Email Filtering tab.
The Email Filtering page appears.
2. In the Options area, click
or next to the desired protocol.
Configuring Email Filtering Advanced Settings
Note: If the ZoneAlarm router is remotely managed, contact your Service Center
administrator to change these settings.
To configure Email Filtering advanced settings
1. Click Services in the main menu, and click the Email Filtering tab.
The Email Filtering page appears.
2. Next to the Bypass scanning if Service Center is unavailable option, specify
how the gateway should handle Email Filtering when the service is enabled
and the Service Center is unavailable, by doing do one of the following:
• To temporarily block all email traffic, click
.
This ensures constant protection from spam and viruses.
The button changes to
.
• To temporarily allow all email traffic, click
.
This ensures continuous access to email; however, it does not protect against
viruses and spam, so use this option cautiously.
The button changes to
.
When the Service Center is available again, the gateway will enforce the configured
Email Filtering policy.