User guide

Resetting SmartDefense to its Defaults
246 Check Point ZoneAlarm User Guide
In this field… Do this…
Block proprietary
protocol /
Block proprietary
protocols on all ports
Specify whether proprietary protocols should be blocked on all ports, by
selecting one of the following:
• Block. Block the proprietary protocol on all ports. This in effect
prevents all communication using this instant messenger
application. This is the default.
• None. Do not block the proprietary protocol on all ports.
Block masquerading
over HTTP protocol
Specify whether to block using the instant messenger application over
HTTP, by selecting one of the following:
• Block. Block using the application over HTTP. This is the
default.
• None. Do not block using the application over HTTP.
Resetting SmartDefense to its Defaults
If desired, you can reset the SmartDefense security policy to its default settings. For
information on the default value of each SmartDefense setting, see SmartDefense
Categories on page
205.
For information on resetting individual nodes in the SmartDefense tree to their default
settings, see Using the SmartDefense Tree on page
203.
To reset SmartDefense to its defaults
1. Click Security in the main menu, and click the SmartDefense tab.
The SmartDefense page appears.
2. Click Reset to Defaults.
A confirmation message appears.
3. Click OK.
The SmartDefense policy is reset to its default settings.