User guide

Getting to Know Your ZoneAlarm Z100G Router
8 Check Point ZoneAlarm User Guide
Table 2: ZoneAlarm Z100G Router Rear Panel Elements
Label Description
PWR A power jack used for supplying power to the unit. Connect the supplied power
supply to this jack.
RESET A button used for rebooting the ZoneAlarm router or resetting the ZoneAlarm
router to its factory defaults. You need to use a pointed object to press this
button.
• Short press. Reboots the ZoneAlarm router
• Long press (7 seconds). Resets the ZoneAlarm router to its factory
defaults, and resets your firmware to the version that shipped with the
ZoneAlarm router. This results in the loss of all security services and
passwords and reverting to the factory default firmware. You will have
to re-configure your ZoneAlarm router.
Do not reset the unit without consulting your system administrator.
USB Two USB 2.0 ports used for connecting USB-based printers
WAN Wide Area Network: An Ethernet port (RJ-45) used for connecting your cable or
DSL modem, or for connecting a hub when setting up more than one Internet
connection
LAN 1-4 Local Area Network switch: Four Ethernet ports (RJ-45) used for connecting
computers or other network devices
ANT 1/
ANT 2
Antenna connectors, used to connect the supplied wireless antennas