User's Manual

Mixing

Aileron to Rudder Mix

To Program Mixing Function

To access Aileron to Rudder Mix

Use Aileron to Rudder mixing to overcome adverse yaw

characteristics with certain types of aircraft such as the J3

Cub and make coordinating turns easier.

If you accessed the flap option in wing type in the system

setup mode, the elevator to flap mix will display. Rotate the

roller to highlight ELE > FLP then press. Now rotate the

roller to select Ail > RUD and press. The aileron to rudder

Mix screen appears.

Assigning Aileron to Rudder Mix to a Switch

Rotate the roller to highlight Sw: at the bottom of the

screen. Press the roller to access the switch select function

then select the desired switch to turn on/off the aileron to

rudder mix. If you select On, the mix will always be on.

Adjusting Aileron to Rudder Mix Rates

Rotate the roller to highlight the rate values then press.

Note that both rates are boxed. Moving the aileron stick

right or left causes the right or left value only to be

highlighted so you can adjust the values individually. Move

the aileron stick in position to highlight the desired rates

then rotate the roller to adjust the value. Note that positive +

and negative - values reverse the direction of the mix.

Press the roller to accept the rate.

Verify the aileron to rudder mix is working properly and in

the correct direction by placing the active switch in the

active position and moving the aileron stick noting the

rudder position. If the rudder moves in the opposite

direction than desired, the opposite value (positive vs.

negative value) is needed.

Note: the Elevator to Flap mix operates in the same fashion as

alieron to rudder mix.

The Ah6T offers eight mixes in airplane model type. There

is an Elevator to Flap mix, Aileron to Rudder mix, and six

user-programmable mixes that allow the mixing of any

channel to any other channel. Programmable mixes

include a trim offset function that adjusts the mix crossover

point and a trim include function that applies the master’s

trim to the slave channel.

Rotate the roller to highlight Mixing then press. The

following screen appears: