User's Manual

Model Reset
Model Copy
To Access the Model Copy Function
Highlight the desired Trim value then press the roller to
access. Rotate the roller to change to the desired trim
value. Press to accept. Repeat to adjust all trim steps.
Model Reset is typically used to clear the programming for
a model you will no longer be flying. Model Reset resets
the programming for the selected model to factory defaults.
No other model memories will be affected. When a model’s
memory is reset all programming for that model is
permanently deleted and cannot be recovered.
To Access the Model Reset Function
Press and hold the roller while turning on the transmitter.
When System Setup appears on the screen, release the
roller. The AH6T is now in System Setup Mode.
Rotate the roller to highlight Model Reset then press to
access the function.The following screen appears:
Verify that the model displayed on this screen is the model
you wish to reset. Rotate the roller to highlight Reset and
then press to access the Confirm Reset screen.
Highlight YES If you’re sure you want to reset this model to
factory default settings, press the roller. The screen will
return to the main screen.
The Model Copy function copies the currently selected
model’s programming of another model memory. Thirty
model memories are available. Some of the more common
uses of the Model Copy function include:
0RYLQJWKHRUGHURIPRGHOVDURXQGLQPRGHOPHPRU\VR
they can be organized by category, type, etc. Note: You will
need to re-bind after moving models.
Note: You will need to re-bind after moving models
([SHULPHQWLQJZLWKWKHSURJUDPPLQJIRUDQDLUFUDIWZKLOH
preserving a copy of the original setup. Note: If you want to
use the model copy function to try two slightly different
setups with the same model you will need to rebind the
receiver each time you switch between model memories.
&RS\LQJWKHSURJUDPPLQJIRUDQH[LVWLQJPRGHORYHUWRD
new model that is similar. Many pilots find this to be a good
way to provide more accurate baseline programming for the
new model. For example Vibe 50 w/120CCPM mixing, gyro
and governor programming provides a good base
programming for any other nitro powered 120CCPM mixing
helicopter. An Extra 300 with dual aileron and elevator
servos that is properly programmed with dual flap and
dual elevator mixing in Wing Type provides good
foundational programming for another aerobatic airplane
with the same basic control system.
Important: The model memory you are copying to will be
over-written by the copied programming, permanently
deleting any programming that may already exist.
Press and hold the roller while turning on the transmitter.
When System Setup appears on the screen, release the
roller. The AH6T is now in System Setup Mode.
Rotate the roller to highlight Model Copy then press.
The following screen appears:
Verify that the current model displayed on this screen is the
model you wish to copy. If not then see the previous Model
Select to access the desired model. Rotate the roller to
select the model memory (1 - 20) that the model will be
copied to. Select an unused model memory to copy to.
When the desired model memory is displayed, press the
roller to access the Confirm Copy screen.
If you want to Copy this model to the selected model
memory, press the roller to copy. The screen returns to the
main screen when the copy is complete. The original model
memory you just copied will still be selected.
11