EVIRNET™ Base Station Owners Manual © 2004 Zonar® Systems LLC 19518 International Blvd., Suite 101 Seattle, WA 98188 ph 206.878.2459 fax 206.878.3082 www.ZonarSystems.
EVIRNET™ Base Station Table of Contents: Introduction FCC Part 15 Class B Compliance (IC) Industry Canada Compliance Warranty Getting Started System Components System Overview Specifications 2 3 3 4 5 7 8 9 Introduction: The Zonar® Systems EVIRNET™ base station radio is a transceiver operating at 902 to 928MHz in the ISM (Industrial Scientific and Monitoring) band of frequencies.
EVIRNET™ Base Station Compliance Statement (Part 15.19) W A R NING: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference and (2) This device must accept any interference received, including interference that may cause undesired operation. W A R NING: To satisfy FCC RF exposure requirements for mobile transmitting devices, use only supplied and approved antenna is with a reverse FCC Warning (Part 15.
EVIRNET™ Base Station LIMITED WARRANTY. ZONAR has created a safety inspection reporting System known as the Electronic Vehicle Inspection Report (EVIR(tm)), consisting of proprietary software, hardware and a web based collection and reporting system (collectively, the "System"). ZONAR warrants that the hardware provided to you as part of this transaction with ZONAR is free from material defects in workmanship for a period of sixty (60) days after shipment to you (or for one year for hardware you purchase).
EVIRNET™ Base Station Getting Started: Connect the base station to a PC with a 9 pin “DB-9” serial cable (supplied), then connect the 12VDC regulated power supply (supplied) to the base station. On the PC, install the ZonarCom 3.x software if it has not been installed yet. Right click on the ZonarCom 3.x icon and select “Settings Configuration”, this will show a dialog box similar to this: In that dialog box, select “EVIRNET™ (Wireless)”, and the appropriate comm port, then click “Store Config”.
EVIRNET™ Base Station Click on the “Read Settings” box, and notice that the values update: The updating of data from the “Read Settings” button signifies that the PC is communicating with the base station, if it is not; please contact Zonar® Systems for support.
EVIRNET™ Base Station System Components: 1. 12VDC Power Supply 2. EVIRNET™ Base Station (shown with 1/2Wave antenna) 3. Serial Data Cable.
EVIRNET™ Base Station System Overview: The basic system is comprised of a base station connected to a PC, and from one to several hundred remote transceivers located typically in a vehicle.
EVIRNET™ Base Station System Specifications: • Frequency Hopping Spread Spectrum Radio • 902 MHz to 928 MHz • 230mW transmit power (Radiated output @ 3 meters) • -103 dBm Sensitivity • 53 Hopping Channels • Operating Temp -20C to +70C • Range 1500FT Obstructed, 4000FT+ Unobstructed Approved Antennas: Nearson Model S467AH-915S (1/2 Wave Whip) Nearson Model SG101N-015 (omni directional antenna) Page 9 of 9
