User's Manual

1) Only used during checkout “Status” LED does not illuminate

solid green when engine is running

2) Follow all General Guidelines as specified on page 6.

3) All power leads must be connected to the vehicles protected

circuitry (e.g. fuse panel, circuit breaker panel, protected

circuits). Never electrically connect Zonar equipment to

unprotected circuits. (e.g. directly to battery)

4) It is also required that all power leads (Red and White leads)

be protected with a 3 to 5 amp fuse and inline fuse holder

(included) for optimal system protection.

5) Electrical fuses should be installed as close as possible to the

source of power

5) Power Bundle wiring – 4 Pin, 3 wires

A) Red – Constant DC (+8 VDC - +30 VDC), dependent

on system type)

B) Black – Ground must be less than 1 ohm (measure from

4 Pin connector to chassis attachment point)

C) White - Switched Power

The White wire must be connected to a power source

that is active only when the engine is running or the

system will not track idle time properly

1) Engine running (+8 VDC to +30 VDC)

2) Engine NOT running (0 VDC)

3) Engine not running (key position ACC or Accessory

Mode (0 VDC)

Please contact the vehicle manufacturer for any specific

electrical questions

GPS 4 Pin Power Cable

Connect White/Red

Wires to Protected

Fused Terminal

Caution

Connect White/Red

Wires to Protected

Fused Terminal

Caution

NON-TYPICAL

SYSTEM INSTALLATION

Note: Do not follow the instructions on this page unless

so instructed by a Zonar representative