User's Manual

System Check: Minimum Requirements - GPS

1) At a minimum, the installer must perform a “System Check”

to verify proper installation.

2) This procedure covers the minimum requirements for a system

installer. If at all possible a full and complete checkout using

Zonar’s Ground Traffic Control™ website should be performed.

Not all installers will have access to this area, check with a

Zonar Customer Service representative if in doubt.

3) Turn Key On/Engine running, within 2 minutes:

A) GPS Green LED: LED should be solid within 2 minutes

or less. Blinking indicates acquiring satellites, Solid

indicates satellite acquired. GPS antenna must have

a clear view to sky. Do not proceed further until GPS

LED is solid

B) GSM cellular Green LED: LED should be solid within 2

minutes. If blinking, ensure GSM antenna is secure, has

a clear view to the sky and area has cellular coverage.

C) STATUS Green LED: Solid

V 2J Model if blinking or off

i. Call Zonar

D) DL1: Single green blink 1 x per second if J1708/J1587

data is present

E) DL2: Single green blink 1 x per second if J1939 data

is present

F) AUX Red LED: Off (Solid or blinking in the event of

system failure)

G) TAMPER: Off when unit mounted properly in mounting

plate. Solid “On” when not mounted in mounting plate.

4) Turn Key Off, within 2 minutes:

A) DL1: Disregard

B) DL2: Disregard

C) GSM Green LED: Disregard

D) GPS Green LED: Disregard

E) STATUS Green LED: Blinking (Solid may indicate

a problem, check white lead. Call your Zonar

Customer Service Representative if in doubt)

F) AUX: Off (Solid or blinking in the event of

system failure)

Note: A proper and complete system/LED functional check requires

the engine to be running

GPS SYSTEM CHECK