User's Manual

13
INSTALLATION EXAMPLE
Fig. 13-1
Truck Board Bracket and Truck Board Installation
1) Follow all general guidelines as specified on page 6.
2) Locate proper mounting location. See vehicle specific
information table on pages 21-22.
3) Clean and dry windshield surface. To obtain optimum adhesion
the windshield surface must be clean and dry. The best surface
cleaning solvent is an isopropyl alcohol/water mixture (rubbing
alcohol).
4) Remove the backing from the peel-and-stick (see Fig. 13-1
or 13-2). Press and hold mounting position for 10 seconds to
assure good adhesion.
5) Complete cable routing and connect Truck Board to V2JE
unit.
Fig. 13-2
One Piece Windshield Split Windshield
Standard Back
Angled Back