Mount Assembly Instructions

Installing Shadow Plates
• Shadow Plates come in four pieces (2 pieces on UTRF-064). The plate that has a
Zomeworks sticker is designed to be installed on the NE corner of the rack.
• Install the Shadow
Plates so that the
ends of the plates are
even with the ends of
the Canisters and they
overlap by
approximately 2” in the
middle.
• Using the 1/4” round-
head bolts, lock
washers, and wide flat
washers provided,
install as shown.
Installing Storm Collar
• The Storm Collar offers additional
protection from high wind / storm
events and can also be used when
building or maintaining the rack. The
collar is an anchor point for running
ropes or ratchet straps (to be
provided by the customer) from the
four corners of the rack.
• The installation height of the Storm
Collar is not critical – we recommend
36” to 48” above the ground level for
easy access.
Balancing and Counterweight Adjustments
• Balancing and set-up is crucial to getting the most out of your Track Rack™
• Start by ensuring that the module rails are installed equidistant from the center axle.
• Pay attention to balance when installing additional components (inverters, wires /
conduit, etc.)
• Track Racks™ will work within a range of Counterweight adjustments.