Mount Assembly Instructions

the 3/8” slot facing the outside edge of the Rail Slider, and either the 1/4” or 5/16” slot
on top (depending on hardware used) – mark a line.
Pre-Installing Mounting Hardware
• Now that the Extruded Rails have been marked,
slide the provided module mounting hardware (1/4”
or 5/16” x 5/8” hex bolts) into the tracks at the
approximate mounting locations. It is only necessary
to locate the bolts in the general area of the module
frame holes – this will make the installation of the
modules easier. Also slide two 3/8” round head bolts
to the center of the marked lines.
Installing Rails on Truss Tubes
• Using the marked lines as a guide, align the Extruded Rail to the Rail Sliders. Install
one flat washer and Nylock nut. Loosely tighten the nut.
• In the process of installing the rails, use a measuring tape to verify that the rails are
square and parallel with the rack.
Installing Modules
• The first module should be installed flush with the edge of both Extruded Rails. Make
any required adjustments to get the hex bolts lined up with the module mounting holes
before installing the hex nut. Once the module is in place, tighten backing nut to no
more than 75 in-lb (6.25 ft-lb) torque. When installing subsequent modules, refer to the
layout drawing for the correct spacing between modules, this is usually 1/4” to 1/2”.
• When all modules have been installed, verify that everything is square and the
modules are equidistant from the center axle. Tighten hardware if necessary.
• Use the zip-ties provided to route the copper transfer tube along the backside of the
modules.