User manual

Indicators and Connecting
Front panel
The following figure illustrates the front panel of the Broadband Wireless Router (AP):
1. When link is established, the LED is On.
2. When the device is transferring data, the LED is Blinking.
Rear Panel
The following figure illustrates the rear panel of your Broadband Wireless Router (AP).

PWR: Power Switch.

WAN: This RJ-45 10 Base-T port connects to an Ethernet port of xDSL/ATU-R
broadband device.

LAN port L1/L2/L3/L4: 10/100 Base-TX, 4 port auto-sensing & crossover Ethernet
switching hub (LAN interface).

12VDC
: 12V power connector.

RST: Factory default reset switch.
To restore factory defaults, you do not need to power off the device. Push a small, stiff object
into the RST hole to press down the button. Keep pressing and wait fort 3 seconds (the DIAG
LED will illuminate about 3 seconds and turn off) to release the button. The device will
automatically restart. During restart, do not turn on/off the device and wait for the device to
boot up.
10