Specifications

converter 1.5

2000 - 2005 urr Sound Technologies Inc.
51
audio midi data reduction settings
audio parameters : midi conversion settings : data reduction settings
[ F3 – F7 – F6 ]
The parameters on this particular menu page only impact continuous controller audio to midi
conversion; trigger mode audio to midi conversion does not employ (or require) data reduction.
continuous controller reject (cc reject)
Selects the ratio of converted values to transmitted midi messages. For instance, with a value of 0,
every analysis value is converted into a midi message and transmitted (most often resulting in a very
dense stream of midi data, especially if all six channels of audio are being converted with the same
stream density). With a value of 4, only every fourth value is converted into a midi message and
transmitted. Possible values are 0 to 99, with a value of zero disabling data reduction.
reject threshold
This parameter controls the amplitude change upon which data rejection is temporarily abandoned in
order to allow sudden fast peaks to be accurately converted and transmitted immediately. This allows
for data to be thinned when there is little change in the amplitude of the input waveform, yet gives
priority to sudden and musically important shifts in amplitude. Possible values fall between 0 and 127;
with a value of zero or one, any change in amplitude is given priority which effectively disables data
reduction.