Specifications
converter 1.5
2000 - 2005 urr Sound Technologies Inc.
21
The last parameter,
“force clock compatibility”, is automatically adjusted by converter during runtime if
needed, and should not be modified unless converter was forced to change it and you wish to reset
converter to use the original midi clock generator engine.
Once you have customized these settings to your specific needs, save the file and you’re ready to run
converter.
The file
The file The file
The file
hardware.cfg
looks like t
looks like t looks like t
looks like this (default settings):
his (default settings):his (default settings):
his (default settings):
# CONVERTER HARDWARE SETTINGS CONFIG FILE
# ---------------------------------------------------------------------------
# ====== Do not add text or otherwise change the line spacing of this file.|
# |NOTE| Just edit the number for the parameter you need to change. |
# ====== Altering the layout of this file may cause converter to not load. |
# ---------------------------------------------------------------------------
# SOUNDCARD TYPE + CORE INPUT MODE
# ___________________________________________________________________________
# MODE | SOUNDCARD | INPUT MODE | CARD MODE |
# ---------------------------------------------------------------------------
# 0 | Roland/UART-MODE MPU-401 | MIDI | SINGLE |
# 1 | Gravis Ultrasound | MIDI | SINGLE |
# 2 | Gravis Ultrasound | AUDIO | SINGLE |
# 3 | SoundBlaster 16 or newer | MIDI | SINGLE |
# 4 | SoundBlaster 16 or newer | AUDIO | SINGLE |
# 5 | SoundBlaster AWE-64 | AUDIO & MIDI | SINGLE |
# 6 | SoundBlaster Pro or clone | AUDIO | SINGLE |
# 7 | SoundBlaster 2.x or newer | MIDI | SINGLE |
# 8 | SoundBlaster Pro & MPU-401 | AUDIO | DUAL |
# 9 | SoundBlaster Pro & MPU-401 | AUDIO & MIDI | DUAL |
# 10 | SoundBlaster 16(+) & MPU-401 | AUDIO & MIDI | DUAL |
# 11 | Gravis Ultrasound & MPU-401 | AUDIO & MIDI | DUAL |
# 20 | No Sound Card (video test) | NO I/O | N/A |
# ---------------------------------------------------------------------------
4
# AUDIO INPUT BUFFER SIZE (in bytes)
# can be no smaller than 12 and no greater than 256; default is 80.
# settings lower than 72 will automatically disable joystick input.
80
# ---------------------------------------------------------------------------
# SETTINGS SPECIFIC TO GENERIC UART MPU-401 ONLY,
# OR MPU-401 IN DUAL CARD INPUT MODE.
# ---------------------------------------------------------------------------
# MPU-401 IRQ
# possible settings: 2,3,4,5,6,7,9,10,11,12,13,14,15
2
# MPU-401 BASE ADDRESS
# possible settings: 300,310,320,330,332,334,336,340,350,360,370,380
330
# ---------------------------------------------------------------------------
# FORCE CLOCK COMPATIBILITY FOR CERTAIN HARDWARE.
# ---------------------------------------------------------------------------
# ** WARNING ****************************************************************
# DO NOT CHANGE THE FOLLOWING PARAMETER UNLESS YOU ARE CERTAIN YOU NEED TO.
# CONVERTER WILL AUTOMATICALLY ADJUST THIS BASED ON PERFORMANCE REQUIREMENTS.
# ***************************************************************************
#
# FORCE CLOCK COMPATIBILITY
# 1=ON, 0=OFF
0
# END OF CONFIG FILE.========================================================