Manual

Chapter 2 Configuration Parameters
36 9650-1201-01 Rev. M
Power Save Mode at Power Up
When this parameter is set to Yes, the unit automatically enters EtCO
2
power save mode when
powered on with a CAPNOSTAT sensor connected. The user must then enable the EtCO
2
device using the Param/EtCO2 softkey menu before use.
Values are as follows:
EtCO
2
Average On Power Up
This parameter sets the default time period over which the EtCO
2
values are averaged.
Values are as follows:
Possible Values: Yes, No
Default: No
Possible Values: 1 breath, 10 seconds, 20 seconds
Default: 10 seconds