Owner's manual

E SERIES - NONINVASIVE BLOOD PRESSURE (NIBP) OPTION INSERT
6 9650-1214-01 Rev. G
How Do I Read the Display?
After each measurement, the NIBP display area displays
measured systolic, diastolic, and mean blood pressure
values.
To access most NIBP features, you must press a softkey
with the appropriate softkey label. To facilitate quick
reaction in emergency situations, you can control certain
NIBP features by pressing the NIBP button.
Note: Depending on the options included in your
E
Series unit, your display may differ slightly from
the illustrations in this insert.
The NIBP display area in the upper left corner of the
monitor screen consists of:
• Symbols that represent the status of blood pressure
measurements.
• Numbers that represent the measurement values
(refer to the following figure and table).
Condition Adjustment/Response
The unit cannot detect
systolic pressure
The unit automatically
increases the cuff inflation
pressure and completes
the blood pressure mea-
surement
The unit cannot detect
systolic, diastolic or
mean pressure after
180 seconds
The unit aborts the blood
pressure measurement
and deflates the cuff
The unit detects a
fault
The unit displays a corre-
sponding error message
on the monitor and aborts
the measurement
#(!2'%2/.
35--!29
#/$%
-!2+%2
.)"0

021,725
(&*

1,%3



6S2

&2

P
P
+J

55
(&*
,, 
[
,%!$
3):% (2
3DUDP :DYH $ODUPV
/HDG
,'
NIBP
Display
Area
Softkey Label
NIBP Button
Softkeys
Display Symbols Status
Not taking any NIBP measure-
ments
Taking a single measurement
alternating with
Taking a STAT measurement
alternating with
Taking an Auto measurement
alternating with
Between Auto measurements
Alarms enabled
Alarms disabled
1,%3




Cuff Inflation
Status Bar
Alarm
Diastolic BP
Systolic BP
Mean BP
* = artifact
1,%3
PP+J
1,%3
67$7
1,%3
$872
1,%3
$872
PP+J
1,%3
PP+J