Manualshelf

Owner manual

ManualsBrandsZOLL ManualsHealth and hygieneE Series Monitor Defibrillator Rev D
51525354555657585960
E Series Service Manual
9650-1450-01 Rev. D 2-7
CONFIRM MANUAL MODE Displayed when manual mode is entered. Alerts user to
confirm that manual mode is desired.
DEFIB DISABLED User prompt issued simultaneously with other faults if
defib is disabled.
Possible configuration problem. Replace high
voltage module. Call ZOLL Technical Support.
DEFIB FAULT 71 More than 50 internal dumps occurred in less than 20
minutes.
Turn the unit to OFF and back on. If fault persists,
replace high voltage module.
DEFIB FAULT 72 Charging inhibited, voltage out of range.
Turn the unit to OFF and back on. If fault persists,
replace high voltage module.
DEFIB FAULT 76 Capacitor voltage too high for selected energy.
Replace high voltage module or capacitor.
DEFIB FAULT 77 Capacitor voltage > than absolute rated max. Replace high voltage module or capacitor.
DEFIB FAULT 78 Unable to charge defib cap.
Replace high voltage module or capacitor.
DEFIB FAULT 79 Defibrillator charging too slowly. Replace high voltage module or capacitor.
DEFIB FAULT 80 4 defibrillator faults detected within 20 second period. Replace high voltage module or capacitor.
DEFIB FAULT 81 Discharge switch in undefined state.
Replace high voltage module or capacitor.
DEFIB FAULT 84 “Upper” discharge transistor shorted (measured via
applicable A/D channel).
Replace high voltage module.
DEFIB FAULT 85 “Lower” discharge transistor shorted (measured via
applicable A/D channel).
Replace high voltage module.
DEFIB FAULT 86 One discharge switch closed during power up test.
Replace paddles, control board or system board.
DEFIB FAULT 87 Both discharge switches closed during power up test. Replace paddles, control board or system board.
DEFIB FAULT 94 Processor fault causing safety monitor port to be non-
functional.
Replace system board, high voltage module or
capacitor.
DEFIB FAULT 95 Safe or shutdown line is not functional. Replace high voltage module.
DEFIB FAULT 108 VMON voltage is less than the target energy during
charging.
Replace high voltage module or capacitor.
Error Message Explanation User
Advisory
Technical Action