Users Guide Instruction Manual

Page 2-10 P/N 11440-001 Rev. 3
User Guide
The Battery is mechanically keyed so that it can only be inserted in one orientation. Do not force or slam
the Battery into the Battery compartment. If resistance is met, check for appropriate orientation, and
check to insure there are no obstructions to Battery insertion and that the Battery Latch is open.
Ensure that the Battery is securely latched (snaps into place) before moving the AutoPulse Platform or
initiating chest compression.
To remove the Battery, rst rotate the Battery Latch into the open position as shown in Figure 2-11. Then
hold the AutoPulse Platform rmly and grip the Battery while pressing the nger latch upwards to
disengage the locking bar (see Figure 2-11), then pull the Battery straight out until it fully clears the
Battery compartment.
Caution: Only use ZOLL Batteries specically designed for use with the AutoPulse. The use of other
batteries may cause permanent damage to the AutoPulse and will void the warranty.
2.3 Administrative Menu: User Pre-set Options
There are several options that may be pre-set by the user prior to deployment of the AutoPulse. These
options are:
Compression mode
Mute duration
Tone volume
Additionally the Administrative Menu allows you to access the following information (refer to section
Section 3.7, “Viewing AutoPulse Platform Information,” on page 3-19):
The last patient session
The AutoPulse Platform
The AutoPulse Battery