Owner manual

P/N. 12457-001 Rev. 2 Page 5-1
Power System User Guide
5 Using the AutoPulse Battery
5.1 AutoPulse Li-Ion Battery Status Check
To determine if an AutoPulse Li-Ion Battery needs to be charged, press the Status Check button on the
AutoPulse Li-Ion Battery (see Figure 5-1).
Figure 5-1 AutoPulse Li-Ion Battery Status Check Button and Status LEDs
The AutoPulse Li-Ion Battery status light-emitting diodes (LEDs) will illuminate (refer to Table 5-1).
Table 5-1 AutoPulse Li-Ion Battery Status LEDs (Page 1 of 2)
Status LEDs Definition Action
Green The AutoPulse Li-Ion Battery is fully
charged.
The AutoPulse Li-Ion Battery is ready for use in
the AutoPulse.
Yellow The AutoPulse Li-Ion Battery is not fully
charged.
Charge the AutoPulse Li-Ion Battery.
Refer to Chapter 4, “Operating the AutoPulse
Multi-Chemistry Battery Charger” for more
information.
Green flashing The AutoPulse Li-Ion Battery has
exceeded its expected service life of three
years from its date of manufacture;
nonetheless, it is fully charged.
ZOLL recommends replacement of Batteries that
have exceeded their expected service life; however,
this AutoPulse Li-Ion Battery is fully charged, and
can be used in the AutoPulse.
Yellow flashing The AutoPulse Li-Ion Battery has
exceeded its expected service life, and is
not fully charged.
ZOLL recommends replacement of Batteries that
have exceeded their expected life. Charge the
AutoPulse Li-Ion Battery to determine if it remains
functional. Refer to Chapter 4, “Operating the
AutoPulse Multi-Chemistry Battery Charger” for
more information.
Red-flashing The AutoPulse Li-Ion Battery has
• failed the Performance Test
• failed a Test-Cycle
• exceeded five years from its date of
manufacture
The AutoPulse Li-Ion Battery has failed and should
not be used.
Refer to Section 6.2.6, “Disposing of AutoPulse
Batteries” for more information.
Status Check Button