RE LT STAINLESS MUG SM-EC Instruction Manual Name of Each Part Lid Cover Lid Cover Gasket e Stopper Cover Stopper Valve Packing Stopper Gasket LT Set ¥ Mouth Ring ¥ Mouth Ring Gasket ¥ Mouth ® Bo sure that all parts are attached firmly before sate use. Please read these instructions before use, and keep for future reference.
Important Safeguards ® Please follow these instructions to prevent scalding, deterioration and discoloration of beverages, as well as malfunction and staining of the Mug. Do not allow infants or small children to use this product. Keep out of the reach of infants and small children. Mishandling may cause injury or scalding. Do not place near heat sources such as gas stoves, ovens and heaters. Doing so may cause deformation or discoloration of the Mug. Do not heat in a microwave.
Important Safeguards ® Please follow these instructions to prevent scalding, deterioration and discoloration of beverages, as well as malfunction and staining of the Mug. When filling the Mug with sports drinks: ® Rinse the inside of the Main Body as soon as possible after consumption to prevent rust and/or pinholes. ® Clean the inside using a soft sponge to protect the nonstick coating from being scratched.
Warnings & Cautions Do not allow hot kettles to touch the Mouth Ring or the mouth of the 7~ Main Body. 2 ) The Mug may tip over, >< causing scalds. Mouth * Be sure that the Stopper Gasket, Valve Packing and Lid Cover are attached properly to prevent beverages from leaking. Do not tilt the Main Body suddenly when drinking. The beverage may spill and cause scalding or stain clothes. Do not leave a tea bag inside and close the Lid Set. The tea bag may swell and cause leakage or cause drinks to spill out.
How to Take Care of Your Mug ® Clean the product after each use to prevent cords, dirt and mold, and to keep the product sanitary. @ For better usage, please remember to clean after every use. @ Wash with warm water and mild dish washing liquid ® using a soft sponge. N Rinse, shake a few times and wipe dry. i ® Remove the Stopper Gasket and Valve Packing from the Lid the L Set and the Mouth Ring Gasket from the Mouth Ring before {01 T washing. @ Please use a small brush (sold in stores} if necessary.
How to Take Care of Your Mug, Continued To Remove Rust Spots and Water Stains: You may find rust spots or water stains caused by impurities in the water. To remove these stains, fill the Main Body with hot water with 10% vinegar and let it stand for 30 minutes to an hour without attaching the Lid ¥Set, then wash the interior thoroughly.
How to Disassemble the Parts H Lid Set move the Lid Cover. old the Tab and pull apart as illustrated. Push the Tabs in then push the Stopper out. g@ Remove the Lid Cover Gasket. Remove the Lid Cover Gasket utilizing the Small Opening. move the Valve Packing. Wuhan removing the Valve Packing, ba careful not to damage it with your nails. \ Valve Packing Stopper . Please follow the steps in reverse to put the parts back together.
