Operating instructions

- 31 -
Home Made
Original Bread
Variations
Programmable setting lets you use your favorite recipes!
HOME MADE
1-5. Follow the same procedure as steps 1-5 for Basic Bread (see page 11).
Home Made Setting
Kneading
First
rising
Stir
down
Stir
down
Second
rising
Third
rising
Baking
Keep
warm
Preheating
Beep
Complete Beep
CRUSTY FRENCH
1-1/2 cups Water
4-1/2 cups Bread Flour
1-1/2 tsp. Salt
1 T
bsp. Butter
3 tsp. A
ctive Dry Yeast
CRUSTY FRENCH (1.5 lbs. SIZE)
1-1/8 cups Water
1/2 Tbsp. Butter
1 tsp. Salt
3-1/4 cups Bread Flour
1-1/2 tsp. A
ctive Dry Yeast
The above recipe is for baking French bread suing the "Home Made" setting which can
be programmed for the desired time.
On conventional bread makers, each bread baking cycle time is preprogrammed,
and does not allow any changes to the baking or rising time. The BBCC-V20’s "Home Made" setting
allows you to program, to lengthen or shorten, each of the cycles in the baking process. This allows
you to adapt your favorite bread recipes for use in the Home Bakery Traditional.
1-5, 7-9. Follow the same procedure as steps 1-5, 7-9 for Basic Bread (see page 11~12).
For programming the time for each process before baking starts
6. Program the time for each process.
1) Select "Home Made" using the SELECT COURSE key.
2) Press the CYCLE key.
(The current process and current time setting are displayed.)
• T
he factory default setting for Home Made is "French Bread" (4:00).
3) If the current time setting is acceptable, press the CYCLE key.
If you want
to change the time, press the T
IME key. (The time display flashes. To reset,
press the STA
RT/RESET key.) After you complete the setting, press the CYCLE key. (The
displayed time stays on.)
4) Display appears according to the process flow.
• Set the time for each process by following the procedure above, by referring to the table for
maximum programmable time for each process. (Each press of the T
IME key increases the time
in 1-minute increments.)
• Keep Wa
rm time is not programmable. Set either ON (60 minutes) or OFF.
• A
fter Keep Warm setting is complete, press the START/RESET key. The time length required for
completion is displayed according to your setting. If you want to change, repeat steps 1-4, above.