Submittal Sheet

© Copyright 2015 Zoeller
®
Co. All rights reserved.
502-778-2731 | 800-928-7867 | 3649 Cane Run Road | Louisville, KY 40211-1961 | www.zoeller.com
G) OUTDOOR BASIN, COVER, AND RAIL SYSTEM
ASSEMBLIES - STANDARD EQUIPMENT
• Fiberglass basin with anti-flotation ring
• 1¼" galvanized pump discharge piping to disconnect
• 1¼" PVC discharge pipe from disconnect
• 1¼" Adaptaflex discharge pipe seal
• Stainless steel square guide rail
• 1' (0.3 m) pull rod
• 8' (2.4 m) stainless steel lifting cable for basin depths to 84" (213 cm)
[12’ (3.7 m) stainless steel lifting cable for basin depths of 96" (244 cm)]
• 1¼" PVC ball valve(s)
• 1¼" cast iron check valve(s)
• 1-4" rubber inlet pipe seal (field-installed)
• Fiberglass cover
SIMPLEX
 24" x 48" (61 x 122 cm) P/N 33-0022 WGT. 206 lb (93.4 kg)
 24" x 60" (61 x 152 cm) P/N 33-0023 WGT. 219 lb (99.3 kg)
 24" x 72" (61 x 183 cm) P/N 33-0024 WGT. 233 lb (105.7 kg)
 24" x 84" (61 x 213 cm) P/N 33-0057 WGT. 264 lb (119.7 kg)
 24" x 96" (61 x 244 cm) P/N 33-0025 WGT. 277 lb (125.6 kg)
DUPLEX
 36" x 48" (91 x 122 cm) P/N 33-0034 WGT. 367 lb (166.5 kg)
 36" x 60" (91 x 152 cm) P/N 33-0035 WGT. 389 lb (176.4 kg)
 36" x 72" (91 x 183 cm) P/N 33-0036 WGT. 472 lb (214.1 kg)
 36" x 84" (91 x 213 cm) P/N 33-0059 WGT. 499 lb (226.3 kg)
 36" x 96" (91 x 244 cm) P/N 33-0037 WGT. 525 lb (238.1 kg)
OPTIONS:
• All stainless steel fitted
• Larger diameter or deeper basins (allow for overhead clearance)
I) BALL VALVE
1¼" IPS
 P/N 30-0165
WGT. 2 lb (0.9 kg)
1½" IPS
 P/N 30-0166
WGT. 2 lb (0.9 kg)
2" IPS
 P/N 30-0167
WGT. 2.5 lb (1.1 kg)
H) RAIL SYSTEMS - (FIELD-INSTALLED)
Z-Rail Disconnect System for 1¼" pump discharges (Rail System
discharge is 2" NPT male thread)
Ductile Iron Constructions
 P/N 39-0134 WGT. 43 lb (19.5 kg)
With Stainless Steel Upper
Rail Support
 P/N 39-0135 WGT. 43 lb (19.5 kg)
Intermediate Stabilizer Bracket for every 12' (3.7 m) of depth.
Stainless Steel
 P/N 39-0139 WGT. 6 lb (2.7 kg)
Square Guide Rail System for systems less than 96" (244 cm) deep.
BASIN DEPTH
 48" (122 cm) P/N 39-0054 WGT. 90.5 lb (41.1 kg)
 60" (152 cm) P/N 39-0055 WGT. 94.5 lb (42.9 kg)
 72" (183 cm) P/N 39-0056 WGT. 98.5 lb (44.7 kg)
Fits both round and square basins. Includes square guide rail. Basins
over 72" (183 cm) deep require one additional angle arm bracket.
 P/N 39-0070 WGT. 11 lb (5 kg)
1' (0.3 m) “L”
 P/N 39-0069 WGT. 0.5 lb (0.2 kg)
2.5' (0.8 m) “L”
 P/N 39-0006 WGT. 1 lb (0.5 kg)
3.5' (1.1 m) “L”
 P/N 39-0007 WGT. 1.5 lb (0.7 kg)
4.5' (1.4 m) “L”
 P/N 39-0008 WGT. 1.5 lb (0.7 kg)
5.5' (1.7 m) “L”
 P/N 39-0009 WGT. 2 lb (0.9 kg)
J) PULL RODS FOR SQUARE
GUIDE RAIL SYSTEMS ONLY
(Field-Installed Systems)
K) STAINLESS STEEL LIFTING CABLE
(Field-Installed Systems)
8' (2.4 m)
 P/N 39-0031 WGT. 1 lb (0.5 kg)
12' (3.7 m)
 P/N 39-0032 WGT. 1 lb (0.5 kg)
16' (4.9 m)
 P/N 39-0033 WGT. 1 lb (0.5 kg)
20' (6.1 m)
 P/N 39-0034 WGT. 1 lb (0.5 kg)
24' (7.3 m)
 P/N 39-0035 WGT. 1 lb (0.5 kg)
* Required for basin depths over 72" (183 cm) (Square Guide
Rail) and over 12' (3.7 m) (E-Z Out Rail). Allow for overhead
clearances.
** For Square Guide Rail only.
Access doors available on field mount systems - consult factory
Special basin configurations - consult factory
Junction box mounting and assembly - consult factory
PREPACKAGED AND JOB READY SYSTEMS
INDOOR
SIMPLEX DUPLEX
REQ. REQ. REQ. REQ.
1 Grinder P/N _____________________ (A) 2 Grinders P/N _____________________ (A)
1 Simplex control panel P/N _____________________ (B) 1 Duplex control panel P/N _____________________ (B)
1 Variable level fl. sw. assm. P/N _____________________ (C) 1 Variable level fl. sw. assm. P/N _____________________ (C)
1 Basin, cover and hardware P/N _____________________ (F) 1 Basin, cover and hardware P/N _____________________ (F)
OUTDOOR
SIMPLEX DUPLEX
REQ. REQ. REQ. REQ.
1 Grinder P/N _____________________ (A) 2 Grinders P/N _____________________ (A)
1 Simplex control panel P/N _____________________ (B) 1 Duplex control panel P/N _____________________ (B)
1 Variable level fl. sw. assm. P/N _____________________ (C) 1 Variable level fl. sw. assm. P/N _____________________ (C)
1 J-box P/N _____________________ (E) 1 J-box P/N _____________________ (E)
1 Basin, cover and hardware P/N _____________________ (G) 1 Basin, cover and hardware P/N _____________________ (G)
FIELD-MOUNT SYSTEMS
SIMPLEX DUPLEX
REQ. REQ. REQ. REQ.
1 Grinder P/N _____ (A) 2 Grinders P/N _____ (A)
1 Simplex control panel P/N _____ (B) 1 Duplex control panel P/N _____ (B)
1 Variable level fl. sw. assm. P/N _____ (C) 1 Variable level fl. sw. assm. P/N _____ (C)
1 Junction box P/N _____ (E) 1 Junction box P/N _____ (E)
1 Rail system P/N _____ (H) 2 Rail systems P/N _____ (H)
1 Angle arm/intermediate bracket* P/N _____ (H) 2 Angle arm/intermediate bracket* P/N _____ (H)
1 Pull rod** P/N _____ (J) 2 Pull rods** P/N _____ (J)
1 Stainless steel lifting cable P/N _____ (K) 2 Stainless steel lifting cables P/N _____ (K)