Submittal Sheet
(C)
VARIABLE LEVEL FLOAT SWITCHES
P/N 10-0033* Switch without weight and bracket
for E820. WGT. 2 lb (0.9 kg)
P/N 10-0748 Switch without weight and bracket
for I820. WGT. 2 lb (0.9 kg)
P/N 10-0661 1 weight and bracket only.
WGT. 3 lb (1.4 kg)
P/N 10-0689 1 weight only.
WGT. 2.5 lb (1.1 kg)
P/N 10-1366 Set of weights and brackets.
Use with 10-0125/10-1037 and 10-1038.
WGT. 6.5 lb (2.9 kg)
*Remove plug.
(D) CHECK VALVES
1¼" Cast iron NPT female
P/N 30-0163 WGT. 7.5 lb (3.4 kg)
1½" Cast iron NPT female
P/N 30-0164 WGT. 7.5 lb (3.4 kg)
2" Cast iron NPT female
P/N 30-0152 WGT. 10 lb (4.5 kg)
(E) JUNCTION BOXES (Contact factory if used in conjuction with a control panel)
OUTDOOR BASIN INSTALLATIONS
INDOOR BASIN INSTALLATIONS
(B) CONTROL PANELS & ALARM SYSTEMS
STANDARD FEATURES:
• Audible and visual alarm
• Alarm silence switch
• Test switch for alarm and light
• UL listed
Simplex panels:
P/N 10-1037 includes alarm and 3 floats
for E820.
P/N 10-1038 includes alarm and 3 floats
for I820.
P/N 10-0125* includes alarm and 3 floats
for E or I models.
Alarm paks only:
P/N 10-0053 indoor only.
P/N 10-0623 outdoor.
P/N 10-0126 outdoor w/ dry alarm
contacts.
*Branch circuit protection provided by electrical installer.
Qwik-Box connection (for use with WD models only) with seals for (1) power cord, (1) pump cord, and (1)
alarm switch cord. Alarm float switch must operate on low voltage to be used w/ Qwik Box.
P/N 10-0580 WGT. 3 lb (1.4 kg)
4 =holes with seals for (1) pump cord, (3) control float switch cords and (1) conduit connection, use with
control panel/s (B).
P/N 10-0647 WGT. 2.5 lb (1.1 kg)
4 holes with seals for (1) pump cord, (1) control float, (1) alarm switch, and (1) conduit connection for
incoming power and alarm return.
P/N 10-0677 WGT. 2.5 lb (1.1 kg)
4 holes with seals for (1) power cord, (1) pump
cord, (1) alarm switch, and (1) alarm return feed.
P/N 10-0666 WGT. 2.5 lb (1.1 kg)
Note: All variable level float switches in this section are
mechanically activated and do not contain mercury.
(G) OUTDOOR BASIN, COVER, AND RAIL SYSTEM
ASSEMBLIES - STANDARD EQUIPMENT
• Fiberglass basin with anti-flotation ring
• 1¼" PVC discharge pipe
• 1¼" rubber discharge pipe seal
• Stainless steel square guide rail
• 1' (0.3 m) Pull rod
• 8' (2.4 m) stainless steel lifting cable for basin
depths to 84" (213 cm), and 12' (3.7 m)
stainless steel lifting cable for basin depths of
96" (244 cm)
• 1¼" PVC ball valve
• 1¼" cast iron check valve
• 1-4" rubber inlet pipe seal - field-installed
• Fiberglass cover
(F) INDOOR BASIN, COVER, AND HARDWARE -
PREPACKAGED STANDARD EQUIPMENT
• Fiberglass basin
• Rust-resistant steel cover
(epoxy coated)
• Inspection plate
• Pump cover
• 3" Adaptaflex vent seal
• 1¼" Adaptaflex
discharge pipe seal
• Cord seal
• 1-4" rubber inlet pipe seal - field-installed
• Pump support hardware
• 1¼" check valve
• Ball valve
SIMPLEX
24" x 36" (61 x 91 cm) P/N 32-0011
WGT. 107 lb (48.5 kg)
(I) BALL VALVE
1¼" IPS
P/N 30-0165 WGT. 2 lb (0.9 kg)
1½" IPS
P/N 30-0166 WGT. 2 lb (0.9 kg)
2" IPS
P/N 30-0167 WGT. 2.5 lb (1.1 kg)
(H) RAIL SYSTEMS - (FIELD INSTALLED)
Square Guide Rail System for
systems less than 96” deep)
BASIN DEPTH
48" (122 cm) P/N 39-0057
WGT. 90.5 lb (41.1 kg)
60" (152 cm) P/N 39-0058
WGT. 94.5 lb (42.9 kg)
72" (183 cm) P/N 39-0059
WGT. 98.5 lb (44.7 kg)
Fits both round and square basins.
Includes square guide rail
Basins over 72" (183 cm) deep require
one additional angle arm bracket.
P/N 39-0070 WGT. 11 lb (5.0 kg)
SIMPLEX
24" x 48" (61 x 122 cm) P/N 33-0185
WGT. 206 lb (93.4 kg)
24" x 60" (61 x 152 cm) P/N 33-0186
WGT. 219 lb (99.3 kg)
24" x 72" (61 x 183 cm) P/N 33-0187
WGT. 233 lb (105.7 kg)
24" x 84" (61 x 213 cm) P/N 33-0188
WGT. 264 lb (119.7 kg)
24" x 96" (61 x 244 cm) P/N 33-0189
WGT. 277lb (125.6 kg)
OPTIONS
• 1¼" stainless steel pipe from pump to bracket.
• Anti-siphon device.
• Pre-wired conduit (consult factory).
*Other sizes available (consult factory).
1' (0.3 m) “L”
P/N 39-0069 WGT. 0.5 lb (0.2 kg)
2.5' (0.8 m) “L”
P/N 39-0006 WGT. 1 lb (0.5 kg)
3,5' (1.1 m) “L”
P/N 39-0007 WGT. 1.5 lb (0.7 kg)
4.5' (1.4 m) “L”
P/N 39-0008 WGT. 1.5 lb (0.7 kg)
5.5' (1.7 m) “L”
P/N 39-0009 WGT. 2 lb (0.9 kg)
(J) PULL RODS FOR SQUARE GUIDE
RAIL SYSTEMS ONLY
(Field-installed systems)
8' (2.4 m)
P/N 39-0031 WGT. 1 lb (0.5 kg)
12' (3.7 m)
P/N 39-0032 WGT. 1 lb (0.5 kg)
16' (4.9 m)
P/N 39-0033 WGT. 1 lb (0.5 kg)
20' (6 m)
P/N 39-0034 WGT. 1 lb (0.5 kg)
24' (7.3 m)
P/N 39-0035 WGT. 1 lb (0.5 kg)
Z-Rail Disconnect System for 1¼" pump
discharges (Rail System discharge is 2"
NPT male thread)
Ductile iron constructions
P/N 39-0134 WGT. 43 lb (19.5 kg)
With stainless steel upper rail support
P/N 39-0135 WGT. 43 lb (19.5 kg)
Intermediate Stabilizer Bracket for every
12' (3.7 m) of depth.
Stainless steel
P/N 39-0139 WGT. 6 lb (2.7 kg)
© Copyright 2014 Zoeller
®
Co. All rights reserved.
502-778-2731 | 800-928-7867 | 3649 Cane Run Road | Louisville, KY 40211-1961 | www.zoeller.com
(K) STAINLESS STEEL LIFTING CABLE
(Field-installed systems)