Submittal Sheet

ManualsBrandsZoeller ManualsGrinder PumpsShark Series E810 Progressing Cavity Grinder Pump (230V, 1HP, 1P, 7.0 Amps)

SECTION: 2.25.025

FM2796

1216

Supersedes

1015

TECHNICAL DATA SHEET

SEWAGE WASTE SERIES

Models 810, 815 Progressing Cavity Grinder Pumps

SK2533

PRODUCT SPECIFICATIONS

MOTOR

Horse Power 1 (810), 2 (815)

Voltage 230

Phase 1 Ph

Hertz 60 Hz

RPM 1725

Type Permanent split capacitor

Insulation Class B

Amps 7.0 (810), 10.5 (815)

PUMP

Operation Nonautomatic

Discharge Size 1-1/4" NPT horizontal

Cord Length 20' (6 m) standard

Cord Type

SOW or SOOW, multi-wire neoprene

Max. Head 810: 150' (45.7 m), 815: 240' (73.2 m)

Max. Flow Rate 14.6 GPM (55 LPM)

Max. Operating Temp. 130°F (54°C)

Cooling Oil lled

Motor Protection Auto reset thermal overload

MATERIALS

Cap Cast iron

Motor Housing Cast iron

Adapter Cast iron

Pump Housing Cast iron

Upper Bearing Ball bearing

Lower Bearing Ball bearing

Mechanical Seals Carbon/ceramic

Hydraulic Rotor Stainless steel

Hydraulic Stator Buna-N

Hardware Stainless steel

Motor Shaft Stainless steel

Gasket & Square Ring Neoprene

Cutter Hardened stainless steel, Rockwell C55-60

Certied to CSA

Standard C22.2 No. 108

FAMILY OWNED

PROUD

AMERICAN

6-5/8” (143 mm)

8-3/8”

(213 mm)

5-1/4”

(133 mm)

4-3/8”

(111 mm)

10-1/2”

(267 mm)

DIA.

22-3/8” (568 mm)

4” (103 mm)

NOTE: See model comparison chart for specific details.

Product information presented

here reﬂects conditions at time

of publication. Consult factory

regarding discrepancies or

inconsistencies.

502-778-2731 | 800-928-7867 | 3649 Cane Run Road | Louisville, KY 40211-1961 | www.zoeller.com

Summary of content (4 pages)

PAGE 1
SECTION: 2.25.025 FM2796 1216 Supersedes 1015 Product information presented here reflects conditions at time of publication. Consult factory regarding discrepancies or inconsistencies. TECHNICAL DATA SHEET SEWAGE WASTE SERIES Models 810, 815 Progressing Cavity Grinder Pumps MATERIALS PUMP MOTOR PRODUCT SPECIFICATIONS Horse Power 1 (810), 2 (815) Voltage 230 Phase 1 Ph Hertz 60 Hz RPM 1725 Type Permanent split capacitor Insulation Class B Amps 7.0 (810), 10.
PAGE 2
MODEL 815 Gal. 14.6 14.4 14.0 13.2 12.5 11.7 10.9 10.1 9.4 9.0 8.6 7.8 7.0 6.3 5.5 72 Liters 55 55 53 50 47 44 41 38 36 34 33 30 27 24 21 PSIG 110 240 100 220 64 90 200 56 48 80 180 160 70 LOW PRESSURE SEWER DESIGN PRESSURE (150 FT OR LESS) 140 60 40 120 32 24 50 100 80 60 TYPICAL OPERATING RANGE 20 40 8 1 HP 40 30 16 2 HP TOTAL DYNAMIC HEAD MODEL 810 Meters 1.5 3.0 6.1 12.2 18.3 24.4 30.5 36.6 42.7 45.7 48.8 54.9 61.0 67.1 73.
PAGE 3
QWIK BOX w/ FLOAT SWITCH B) ALARM PANEL  P/N 10-0623 Indoor/Outdoor high water PLUGGER PANEL B) CONTROL PANEL B) CONTROL PANEL  P/N 10-2006 Plugger panel, NEMA 4X with  P/N 10-1212 Simplex panel, NEMA 4X, high water alarm and 230 volt receptacle. alarm with 15' (5 m) control switch.  P/N 10-0126 NEMA 4X high water alarm with 15' (5m) control switch and dry contact.  P/N 10-4012 Indoor high water alarm with 15' (5m) control switch.
PAGE 4
PREPACKAGED AND JOB READY SYSTEMS ACCESSORIES FOR FIELD-ASSEMBLED SYSTEMS FLEX-HOSE DISCHARGE ASM. P/N 10-2038 with 30" (76 cm) hose  Z-RAIL® DISCONNECT SYSTEM  P/N 39-0137 1-1/4" (3.2 cm) H x 1-1/4" (3.2 cm) V Ductile Iron  P/N 39-0138 1-1/4" (3.2 cm) H x 1-1/4" (3.2 cm) V with stainless steel upper bracket  P/N 39-0139 Intermediate bracket stainless steel STAINLESS STEEL LIFTING CABLES AND ROD  P/N 39-0031 8' (2.4 m) Cable  P/N 39-0032 12' (3.7 m) Cable  P/N 39-0069 1' (0.