Submittal Sheet
SECTION: 2.25.021
FM2882
0815
Supersedes
0415
TECHNICAL DATA SHEET
SHARK GRINDER
Model 803/805/807 Residential Grinder Pumps
SK3034
PRODUCT SPECIFICATIONS
NOTE: The sizing of effluent systems normally requires variable level
float(s) controls and properly sized basins to achieve required pumping
cycles or dosing timers with nonautomatic pumps.
MOTOR
Horse Power 0.5 - 1.0
Voltage 115/230
Phase 1 Ph
Hertz 60 Hz
RPM 3400
Type Capacitor start / Capacitor run
Insulation Class B
Amps 115 V (7-11) / 230 V (3-5)
PUMP
Operation Automatic & nonautomatic
Auto On/Off Points 13" (33 cm) / 5-3/4" (14.6 cm)
Discharge Size 1.25" NPT
Cord Length 15' (5 m) standard
Cord Type UL listed 3-wire plug
Max. Head 55' (16.8 m)
Cooling Oil
Motor Protection Auto reset thermal overload (1 Ph)
MATER IALS
Cover Cast iron
Motor housing Cast iron
Adapter Cast iron
Pump housing Cast iron
Upper Bearing Ball bearing
Lower Bearing Ball bearing
Mechanical Seals Carbon and ceramic
Impeller Type Non-clogging vortex
Impeller Engineered plastic
Hardware Stainless steel
Motor Shaft 1215 cold rolled steel
Gasket Neoprene
Cutter & Plate 440C Stainless Steel
Product information presented
here reects conditions at time
of publication. Consult factory
regarding discrepancies or
inconsistencies.
®
Your Peace of Mind is Our Top Priority
®
R
Tested to UL778 and
CSA22.2 108 Standard
NOTE: See model comparison chart for specific details.
© Copyright 2015 Zoeller
®
Co. All rights reserved.
502-778-2731 | 800-928-7867 | 3649 Cane Run Road | Louisville, KY 40211-1961 | www.zoeller.com
AUTOMATIC
NON-AUTOMATIC
4 15/16 [125 mm]
17 1/4
[438 mm]
3 15/16 [100 mm]
3 27/32 [98 mm]
8 29/32
[226 mm]
7 1/2
[191 mm]
3 27/32 [98 mm]
4 15/16 [125 mm]
17 1/4
[438 mm]
3 15/16 [100 mm]
3 27/32 [98 mm]
8 29/32
[226 mm]
3 27/32 [98 mm]3 13/16 [97 mm]