Installation Sheet

STEP 2 Float Stop Adjustment

 2.1) Withthepumpinthepit,measurethedesiredoatstopon/offpositionsasshowninFig.2.1.Thesetwodimen-

sions will determine the on/off levels of the pump. The spacing between the upper and lower stops will determine

the amount of water removed from the pit.

Note: ItmaybenecessarytoraisetheoatrodguidetoadjustthestopstothedimensionsdeterminedinStep2.1.

CAUTION

The oat rod guide should NEVER be between the upper and lower stop.

 2.2) Removethepumpfromthepitandadjusttheoatstopsasnecessary.Tightenallscrews.

Note: If a brick, or similar material has been used to raise the pump in the pit, it will be necessary to account for the

thickness of the brick.

Figure 2.2Figure 2.1

SK1776 SK1777

STEP 1 Placement of the Pump in the Pit

Note: Ifyourpithasacover,thenitwillhavetobemodiedtoacceptthe

Aquanot

1.1) Inspect the pit for debris and clean as necessary

1.2) Place the pump in the pit making certain that it is on a stable level

surface. Refer to Figure 1.1.

IMPORTANT: If this pump is to be used as a backup to your primary pump,

then make certain that there is no interference between the two pumps.

The motor is not watertight. It should NEVER bebelowoorlevel.

If necessary, bricks or similar materials, can be placed under the Aquanot

This product is meant to be used as a battery backup pump to

your primary pump only. Consult factory for advice before installing this unit

as a primary pump.

Figure 1.1

SK1775