Install Instructions

1) Connect the toilet bowl to the pump unit with the closet seal as shown.

2) Position the pump unit a minimum of 1/8" from the wall.

3) Lightly mark the closet bolt locations on the ﬂ oor. Set tank/toilet bowl assembly to the side and install closet bolts

at the points marked earlier.

4) Place toilet assembly over closet bolts. Install the anchoring hardware and tighten in an alternating pattern.

Check for level and shim as required. Be careful when tightening bolts or nuts against china to avoid cracking

the china.

STEP 3 Rough-in (stand alone installation)

SK2615

STEP 3-1

STEP 3-3, 3-4

STEP 3-2

1/8"