Operating Guide
5
Copyright © 2020. All rights reserved • 95 North Oak Street • Kendallville, IN 46755
MATERIALS NEEDED:
PVC Glue Tape Measure
Hack Saw Phillips Screwdriver
Flathead Screwdriver PTFE Pipe Thread Sealant Tape
Tongue and Groove Pliers Pipe Wrench
Round File or Sand Paper 2 in. Threaded Connections
(2 in. Slip Union & 1 1/2 in. Slip Union Included)
Shut O Valve On/O Timer
INTRODUCTION
This manual contains information for the proper installation and operation of the Star Water System pool pump.
The instructions in this manual MUST be followed precisely. Failure to install according to dened instructions
will void warranty.
PRODUCT BENEFITS
• See-through strainer cover lets you see when the basket needs cleaning.
• Heavy-duty, high performance motor for quieter, cooler operation.
• Service-ease design gives simple access to all internal parts.
• Handle for easy carrying and moving.
PRODUCT SPECIFICATIONS
INSTALLATION INSTRUCTIONS
10 in
10.4 in
8.1 in
12.6 in
10.7 in
7.6 in
9.5 in
26.5 in
This product should be installed and serviced only by a qualied professional.
PUMP LOCATION
Locate pump as close to pool as practical and run suction lines as direct as possible to reduce friction loss.
Suction line diameter must equal or be larger than the discharge line diameter. Suction lines should have
continuous slope upward from lowest point in line. Joints must be tight (but not over-tightened).
Though the pump is designed for outdoor use, it is strongly advised to protect the electrical components from
the weather. Select a well-drained area, one that will not ood when it rains. Do NOT install pump in a damp
or non-ventilated location. Keep motor clean. Pump motors require free circulation of air for cooling.
PUMP MOUNTING
Install pump on a rm, level base or pad to meet all local and national codes. Fasten pump to base or pad with
screws or bolts to further reduce vibration and stress on pipe or hose joints. The base MUST be solid, level,
rigid, and vibration free.