Install Instructions
4
© Copyright 2014 Zoeller Co. All rights reserved.
WD & WH MODEL INSTALLATION
WIRING DIAGRAM FOR MODELS
Determining Pumping Range
in Inches (1 inch = 2.5 cm)
5 10 15 20 22
9 13.5 18 22 24
cable, pumping range above horizontal
horizontal. Ranges are based on testing in
nonturbulent conditions. Range may vary
due to water temperature and cord shape.
As tether length increases, so does the
variance of the pumping range.
START
RUN
BLUE
MOTOR
(WHITE)
RED
(BROWN)
O.L.
YELLOW
(BLACK)
SWITCH
FLOAT
BLACK
BLACK
WHITE
CAPACITOR
BLUE
(1)
(2)
RED
RUN
WHITE
GREEN
L1
L2
(3)
011835
Note:
may prevent reliable switch operation.
Note: Cable must be mounted in horizontal
position.
22" MAX.
(559 mm)
5" MIN.
(127 mm)
20 AMP SWITCH (WD & WH MODELS)
THREE PHASE WIRING INSTRUCTIONS
FOR YOUR PROTECTION, ALWAYS
DISCONNECT PUMP FROM ITS POWER SOURCE
BEFORE HANDLING.
the panel to wire the system. For automatic three phase pumps,
see automatic 3 phase wiring diagram located to the far right.
wiring has been connected properly to power source, and that
to a valid ground. Momentarily energize the pump, observing the
casing. If rotation is not correct, switching of any two power leads
other than ground, should provide the proper rotation.
must
NONAUTOMATIC
3 PHASE
AUTOMATIC
3 PHASE
(3)
FLOAT
(1)
(2)
BLUE
TAN
COM
NC
CR
RELAY
7
8
B
ORANGE
A
1
2
3
4
(M1)
(M2)
9 6
4
5
WINDINGS
RED
YELLOW
PURPLE PURPLE
OR BROWN
BLACK
RED
WHITE
GREEN
L3L2L1
THERMOSTAT
WHITEWHITE
WHITE
RED
BLUE
MOTOR
(3)
BLUE
RED
BLACK
GREEN/YELLOW
L1
L2
(1)
(2)
YELLOW
L3
GREY
BROWN
SINGLE PHASE WIRING INSTRUCTIONS
FOR YOUR PROTECTION, ALWAYS DISCONNECT PUMP FROM ITS POWER SOURCE BEFORE HANDLING. Single phase pumps
DO NOT UNDER ANY CIRCUMSTANCES
REMOVE THE GROUND PIN.must If the installation does not have such
and ordinances.
Risk of electrical shock. Do not remove power supply cord and strain relief or connect conduit directly to the pump.
rating for the pump to which it is connected.
IMPORTANT NOTICE:
is settled with the insurer in the case where you need to retain possession of the product to support a damage claim you submit to your insurance company.
006848