Part List

3
© Copyright 2012 Zoeller Co. All rights reserved.
1. Read all instructions before beginning installation.
2. Be certain that basin is on a rm level surface.
3. Do not use an automatic plumbing vent device.
4. Do not over-torque lid attachment screws.
5. Always use a check valve on the discharge line.
6. Test operation of pump per STEP 6.
Ten Helpful Hints For Easy Installation
Performance Characteristics
7. Always provide some means to disconnect basin from plumbing for
maintenance purposes.
8. Run unit at least once a month to verify proper operation.
9. The model number and date code can be found on the lid warning label.
10. Plug pump into a properly grounded GFCI receptacle.
009898
Meters
20 6.1
Shut-off Head:
15 4.6
10 3.0
5 1.5
Feet
MODELS
Liters
273
231
170
19.25 ft. (5.9m)
--
19
34
43
--
72
9525
23 ft. (7.0m)
45
129
163
61
72
Gal.
104/132
Liters Gal. Liters Gal.
131
105/110
115/120
18 ft. (5.5m)
38
14
30
144
53
114
-- --
2010
0
GALLONS
LITERS
0
5
504030
80
160
FLOW PER MINUTE
105/110/
8060 70
240
131
PUMP PERFORMANCE CURVE
104/105/110/115/120/131/132
4
TOTAL DYNAMIC HEAD
2
10
15
6
20
FEET
METERS
25
115/120
104/132
1. DO read all installation material included with the pump.
2. DO inspect unit for any visible damage caused by shipping. Contact
dealer if unit appears to be damaged.
3. DO clean all debris from the basin and pump.
4. DO always disconnect pump from power source before handling.
DO always connect to a separately protected and properly grounded
ground fault protected circuit. DO NOT ever cut, splice or damage
power cord. DO NOT carry or lift pump by its power cord. DO NOT use
an extension cord.
Do’s And Don't’s For Installing A Unit
5. DO NOT use a discharge pipe smaller than the pump discharge size.
6. DO test pump immediately after installation to be sure that the system
is working properly.
7. DO review all applicable local and national codes and verify that the
installation conforms to each of them.
8. DO NOT install unit in the ground.