Installation guide
27
3.4 Connection to the TRi command box
e Zodiac TRi salt water chlorinator is designed to operate exclusively using a 220-240 V ac 50 Hz power
supply.
REMINDER: Your appliance MUST be installed by an experienced pool professional.
1. Standard connections: e TRi salt water chlorinator can be connected in one of two ways:
- Either directly connected to the pool ltering system (the appliance is only powered when ltering is active).
- Or connected to a permanent power supply due to the presence of the ow sensor (power supply
protected by a 30 mA ground fault circuit interrupter).
2. Optional connection: If a pump is directly connected to the TRi box (220-240 V ac single phased pump,
maximum consumption 9 A) connect your pool pump to the socket located under the TRi using the supplied
male AUS format plug (this will allow the TRi timer to control ltering times as well).
3. Once all the connections have been made and all glued assemblies are dry (wait for a few hours depending
on the product used) reconnect the mains supply and switch the appliance to the “On” position.
3.5 Description of the TRi control panel
e diagram below shows the functions on your TRi control panel:
1 – LCD Screen
2 – “Menu” buon to access the menu
3 – “Scroll” (Up / Down) buon for chlorine production and menu navigation
4 – “Select” buon to validate a choice
5 – “Boost” buon (corresponding blue indicator)
6 – “On/O” buon
7 – “Low” buon (corresponding blue indicator)
8 – Red “Flow” indicator; no ow safety
9 – Blue “Power” production indicator
10 – Orange “Salt” salt level indicator