Instruction manual

14 15

OnceaconnectionhasbeenmadebetweentheControllerandthe
Chlorinegenerator,itwillneedtobetested.
1. TurnonthepowertotheControllerandtheZodiacTRi.
2. Ifsuccessful,a‘
’symbolwillappearinthetoprighthandcornerofthe
screenafterabout20seconds.
3. Ifthecontrollerdoesnotconnect,turnpowerofftoboththedevices
andtryagain.

Toverifytheconnection:
1. SwitchtheTRiunitonandcheckthecontrollersetting(follow
instructionsunder‘SETTINGCONTROLLER’.
2. Re-testtheconnection.
 Note:Forsafetyreasons,theZodiacTRirevertstotheOFFsettingifthecommunication
connectionislost.


ToconnectaZodiacTRiunittoPoolorSpaValves,youwillneedtomake
a“splice”intothecontrollinesfromtheController,locatedinsidethe
controlleritself.
Forfurtherinformation,consulttheinstallationmanualoftheController
beingused.
