Specifications

Do not attempt repairs on the gas controls or
appliance. Tampering is dangerous and voids all
warranties.
CAUTION
Ne tentez pas d’effectuer des réparations au
système de régulation du débit du gaz ou à
l’appareil. Toute modication non autorisée est
dangereuse et entraîne l’annulation de toutes les
garanties.
ATTENTION
Keep all objects off the top of the heater. Blocking
air ow could damage the heater, and may void
the warranty.
CAUTION
Ne posez aucun objet sur le dessus de l’appareil.
Il pourrait empêcher la circulation de l’air, ce qui
risquerait d’endommager l’appareil et d’annuler la
garantie.
ATTENTION
Be sure that there is water in the pool and that the
surface level is above the skimmer or other inlet of the
pool's lter system.
Conrm that pool water is owing normally
through the pool system and equipment. With any
new pool or spa installation, operate the lter pump
with the heater off long enough to completely clean the
water. This will remove any installation residue from
the water. Clean the lter at the end of this operation
before starting the heater. Start the heater in accordance
with the Operating Instructions section of this manual,
with particular attention to the lighting and shutdown
instructions and temperature control operation.
The heater may not start on the rst try. Air in
the gas line or other start-up situations may cause it to
cycle. It will lock out if ignition is not achieved in three
attempts, see Section 9.2, "Service Codes". To reset the
Legacy Model LRZ electronic heater to provide three
(3) additional attempts, turn off the control and then put
it back in either the Pool or Spa mode.
When the heater starts, immediately feel the outlet
header of the heater to conrm that there is adequate
water ow. The header should not be hot. Normally,
water temperature will rise only a few degrees as it
passes through the heater, and a "hot" header or pipe
indicates low water ow.
When the heater is red for the rst time, the
combustion chamber refractory binder material is
driven out by the heat of the ame. White smoke
and/or sharp odors may be emitted from the vent
during this period. Do not inhale combustion
product fumes at any time, and especially when
these fumes are being emitted. This "burn-in"
period will last only a few minutes.
WARNING
Lorsque l’appareil est mis en marche pour la
première fois, le matériau liant réfractaire de
la chambre de combustion est expulsé par la
chaleur de la amme. De la fumée blanche et
de fortes odeurs peuvent se dégager du tuyau
d’aération à ce moment-là. N’inhalez les fumées
de combustion à aucun moment, surtout au
moment où elles sont émises. Cette période de
combustion ne durera que quelques minutes.
AVERTISSEMENT
When raising the temperature of a cold pool,
program the time clock to turn the pump off 23 hours
after the start time (e.g., If the start time is 2:00 PM,
then set the stop time at 1:00 PM.). This lets the
lter system and heater operate continuously until
the water reaches the temperature setting on the
temperature control. When that happens, the heater will
automatically shut off, but the lter pump will keep
running.
7.3 Operating the Controller
Your new Legacy Model LRZ electronic Pool
Heater is controlled by an advanced microprocessor
based controller that provides a sophisticated yet simple
interface to operate your heater for maximum efciency
and enjoyment of your pool. To locate the control
buttons, see Figure 19.
GAS HEATER IS OFF
PRESS POOL OR SPA
Figure 19. Main Control Panel
Page 25
ENGLISH
Jandy
®
Legacy™ Model LRZE Pool/Spa Heater by Zodiac
®
|
Installation and Operation Manual