Specifications
Installation and Operation Manual
|
Legacy™ Model LRZM Pool/Spa Heater
H0320600 Rev B
INSTRUCTIONS TO LIGHT HEATER
1. Position ON/OFF switch to “OFF”.
2. Turn gas control knob clockwise until it stops at
“ ” (OFF) position.
3. Wait five (5) minutes before lighting pilot.
4. Turn knob on gas valve counterclockwise to
“ ” (PILOT) then push control knob all the way and
hold down. Push the button of the sparker, repeating
until confirming that pilot lights, by observing reflection
on burner tray mirror. Continue to hold the control knob
in for about one (1) minute after the pilot is lit. If it goes
out, repeat steps 3 and 4.
5. Turn gas control knob counterclockwise to “ ”
(ON).
6. After replacing door, set thermostat to desired setting
and turn appliance ON/OFF switch to “ON”. Valve has
built-in delay before coming on.
RELIGHTING
If pilot goes out, repeat steps 1 through 6.
TO SHUT OFF HEATER
To shut off main burners turn gas control knob
clockwise until it stops at “ ” (PILOT). For
complete shut-off press down slightly on knob while
turning clockwise to “ ” (OFF). Do not force.
Position ON/OFF switch to “OFF”.
DO NOT STORE OR USE GASOLINE OR OTHER
FLAMMABLE VAPORS OR LIQUIDS IN THE VICINITY OF THIS
OR ANY OTHER APPLIANCE.
NOTE: SOME EXPOSED PARTS OF THIS HEATER MAY BE
HOT WHEN OPERATING.
1. CAUTION: Do not store pool chemicals or flammable
materials near this appliance.
2. PH LEVEL: Pool Water must be maintained between 7.4
and 7.6 when operating unit (See section entitled "Water
Chemistry" in operating manual).
3. BACKWASHING: Turn heater off 20 minutes before
backwashing or shutting down filter to prevent damage
to unit.
4. WINTERIZE: All gas to unit must be shut off and all water
drained from unit to protect it from freezing damage.
NOTE: THIS DOOR MUST BE FITTED TO UNIT DURING
NORMAL OPERATIONS.
Control Knob
with OFF, Pilot
and ON Position
Regulator
Pilot Adjustment
®
To avoid possible injury, re and
explosion, read and follow these precautions and
all instructions on this appliance before starting the
heater. LP (propane) gas is heavier than air and
will remain at ground level if there is a leak. Before
lighting, sniff at ground level. If you smell gas, follow
these rules:
1. DO NOT light matches. DO NOT turn electric
lights or switches on or off in area. DO NOT use
an electric fan to remove the gas from area.
2. Shut off gas at LP tank.
3. Telephone gas company and re department
for instructions. Give your name, address and
phone number.
If your LP tank runs out of fuel, turn off gas at the
appliance. After the tank is relled, the appliance
must be re-started according to the instructions
located on the inside of the door.
To avoid possible injury, re
and explosion, read and follow these precautions
and all instructions on this heater before lighting the
pilot. If you smell gas, follow these rules:
1. DO NOT light matches. DO NOT turn electric
lights or switches on or off in area. DO NOT use
an electric fan to remove the gas from area.
2. Shut off gas at gas service cock.
3. Telephone gas company and re department
for instructions. Give your name, address and
phone number.
DO NOT attempt repairs on the gas control or
heater. Tampering is dangerous and voids all war-
ranties.