User manual

6. Place the upper part of the Ei cell paddle clamp on the pipe, sliding it into the previously
drilled holes.
IMPORTANT NOTE:
> Water flows through the adaptor in a certain direction. Please
note the direction of the arrows indicating the water flow before
installing it!
> 'UK' English versions only with a 1 1/2 ''pipe: Replace the large flat
ring of the clamp with the specific model supplied (ring in contact
with the pipe).
7. If you are installing the Ei chlorine generator
on a DN50 mm type pipe, insert the reducer
bearing the 'EU' mention into the paddle
clamp lower part (Use the other reducer for a
1 1/2 '' pipe). Important: make sure that the
adapter fits correctly into the notches located
on the lower part of the paddle clamp.
8. Click the lower part of the paddle clamp onto the upper part already in
place on the pipe.
9. Ensure that the O'ring is correctly positioned, then fit the Ei electrode on the
paddle clamp. Note: the electrode has a direction and can only be inserted in
one way (use the foolproof notch).
10. Firmly tighten the locking ring (Hand only tightening!) on the paddle clamp. Make sure you
respect the thread direction - it should screw on easily.
11. Connect the cell wire to the Ei electrode
connectors by following the colour code between
connectors, male and female, as indicated below
(Red to red, black to black and blue to blue).
12. Place the cover back on the Ei electrode and slide the wire in the slot designed for this
purpose located on the side of the electrode.
30
Arrows indicating
the water flow
O'ring
Foolproof
notch
Notches