User manual

When the Ei chlorinator is connected to a controller it is in slave mode and responds to requests.
In this case the Ei Timer settings are ignored and the chlorine production level cannot be changed.
All the other 'MENU' functions are still available.
5.3 WIRING TO THE EXTERNAL CONTROLLER
IMPORTANT: The following instructions must be read together with the installation
guide supplied with the external timer/controller.
1. Remove the grey cover by exercising a pressure on each side as indicated then by pulling
it up.
2. Remove the small white plug located on the lower metal panel of the Ei power pack.
3. Remove the 4 screws maintaining the dark grey cover of the Ei power pack.
4. Carefully open up the Ei control box cover then remove with care the ribbon cable connecting
the 2 electronic cards. Then retrieve the Ei power pack cover.
38
1 2 3
Ribbon cable