User manual

NOTE: When an 'ON' start time is defined a default stop time is proposed. To define the stop

time of your choice just press the and keys to set the time.

To clear the timers:

1. When on the default LCD display press the key. Wait until the 'PRESS OUTPUT TO CLEAR

TIMERS' message disappears.

2. Press the key ; the 'TIMERS CLEARED' message will appear. The Ei programming

is now cleared.

3. Press the key to return to the default LCD display.

4. If necessary re-programme the device (see Setting the timer).

4.5 MANUAL START-UP

In addition to operating via the timer, the Ei can also be started and stopped manually by pressing

the key. The appliance will then operate until the next 'OFF' stop time if no production

time period has been specified, then will switch back to the programmer's mode. This function

may be very useful to conduct some tests.

WARNING: If the Ei appliance is started manually and no stop time has been pro-

grammed (continuous filtration activation), the appliance will operate without any

interruption for a 30 hours maximum time period, then it will turn the power off

automatically ('OFF') in order to avoid an overload of chlorine.

4.6 EXTERNAL CLOCK USE (FILTRATION CONTROL BOX)

In some cases, it may be necessary to link the Ei appliance to an external clock (filtration box

timer for example). In this case, the chlorine production must be activated at the same time than

the pool's filtration. In order for the Ei appliance to operate within that configuration, you should

not have programmed any operating periods ('TIMER').

Process:

1. Clear all existing timer settings (a small 'T' symbol is displayed in the top right of the screen if any

timer settings have been defined). To do this press the key and then the key to clear

the settings (see Setting the timer).

2. Turn on the Ei chlorinator ( key) and set the chlorine production level you need

( key). See the Setting chlorine production below.