User manual

Resetting the clock:

1. When on the default LCD display press the key.

2. After a few seconds the Ei device restarts and the clock is reset ('00:00').

3. Set the clock time using the procedure described above (Setting the time).

4.4 SETTING THE TIMER

The Ei chlorinator is equipped with 2 timers that can be programmed so as to release chlorine

during time periods that are different from the filtration time, and this, up to twice per day.

Note that the timer periods must be included within the filtration periods (no chlorine will be

released when the filtration is not running).

Setting the timer:

1. When on the default LCD display press the key to go to 'TIMER 1' setting. An automatic

message will appear briefly, then the following will be displayed: 'TIMER 1 ON - - : - -'.

2. Press the key to set the start-up hour (The key can be held down to accelerate

incrementation).

3. Press the key to set the start-up minutes (The key can be held down to

accelerate incrementation).

4. Once the desired 'ON' time is set, press the key in order to move on to the 'OFF' time

setting: 'TIMER 1 OFF - -: - -' will be displayed.

5. Repeat steps 2 and 3 to set the stop time.

6. If you need to set a different time period, press the key again in order to switch to

'TIMER 2' and repeat steps 1 to 5 above (Once for the onset time and another time to set

the stop time). If you do not need to program another time setting, press the key to return

to the LCD default display.

Note: once the programming of a time setting has been

made, a small 'T' icon will be displayed in the upper right

corner of your LCD screen.