Product specifications

Page 24

Section 5. Operating Instructions

On/Off

Flow Salt

Output

Indicates level of chlorine

output production.

Each light represents a

20% increment of output

production.

Check salt level indicator

Indicates that there

is not enough ﬂ ow

through the cell

5.2 Turning Power Pack On/Off (Manually)

To turn the Jandy

AquaPure

chlorine generating device on or off press the button.

NOTE Because the power pack is wired to the pump’s power source, the power pack can only be turned on when

the pump is turned on.

5.3 Turning Power Pack On/Off (Using the Pump’s External Timer)

If the power pack is wired to the pump’s external timer and the power to the power pack is on, the power pack will

automatically turn on and off when the pump turns on and off (see Section 3.4). When the power pack is wired as

such, the only setting that must be set manually is the chlorine output level (see Section 5.4).

5.4 Setting the Chlorine Output Level

When setting the chlorine output level you must consider the size of the pool, the amount of use the pool will be

receiving and how hot the weather is. All these factors weigh greatly on the level of output needed. To adjust the out-

put level, follow these steps:

1. Turn the power pack on by pressing the

button.

2. Press the

button to reach the desired output level. The minimum setting is 20% (one amber light). The

output can be adjusted in increments of 20% up to 100%. If the OUTPUT button is pressed beyond 100%, the

output level setting will drop back to 20%.

Figure 25. Control Panel on the Power Pack

Output Setting Amount of time cell will run

20% - one (1) light Cell will run two (2) min. every ten (10) min.

40% - two (2) lights Cell will run four (4) min. every ten (10) min.

60% - three (3) lights Cell will run six (6) min. every ten (10) min.

80% - four (4) lights Cell will run eight (8) min. every ten (10) min.

100% - five (5) lights Cell will run non-stop.

5.1 Control Panel

WARNING

To avoid property damage, serious injury or death, do not operate the electrolytic cell without water circulation. A buildup of

ﬂ ammable gasses which can result in FIRE OR EXPLOSION.