Product specifications

Page 16

3.6.3 Testing the Connection

Once the power pack has been wired to the AquaLink RS Control System or PDA, follow these steps to test the

connection:

1. Apply power to the power pack and the AquaLink RS Control System or PDA.

2. Wait about 20 seconds. If the connection was successful, a Ŧ symbol will appear in the top right corner of the

power pack display.

NOTE If the power pack does not connect to the controller, turn the power off to both devices and repeat steps 1

and 2. If the power pack still does not connect to the controller, re-check the wiring connections (see Section

3.6.2) and the controller setting on the power pack (see Section 3.6.1).

Figure 21. Communication Wiring between Power Pack and AquaLink RS Control System or PDA Network

Jandy

Power Center

Power Pack

OPTIONAL

4321

RED

BLK

YEL

GRN

Red, 4-Pin

Terminal Bar

RED

GRN

YEL

BLK

POS

RED

BLK

7. The Jandy

AquaLink

RS or PDA and power pack use a four (4) wire connection to communicate and can be

wired up to 152.4 m (500 ft) apart. Any outdoor rated four conductor cable, minimum 0.33 mm

(22 AWG), can

be used. Locate the appropriate screw terminals on the circuit board and wire the power pack

to the AquaLink

or PDA red 4-pin terminal bar (see Figure 21).

NOTE The screw terminals on the AquaLink RS or PDA are removable to aid in installation.